How do connect a drive-away awning to my motorhome?

Guy Line Method (Recommended)

• Throw the guy lines, attached to the top corners of the tunnel, over the vehicle and either peg down on the other side or tie to the wheels
• Unpeg to drive-away

Advantages

Greater tensioning of tunnel assisting with water run-off
Higher attachment point for better door clearance
Quicker to reattach upon return to your pitch

Keder Beading Method (optional accessory recommended)

• Dometic drive-away awnings come with a 6mm keder beading sewn along the length of the rear tunnel
• Attach directly to awning rail (if fitted) or channel of cassette awning
• To drive-away, you will need to use drive-away kit:
  - Twin Driveaway Kit 3m
  - Twin Driveaway Kit 4m
• For vehicles without a rail fitted, a Kampa Limpet™ Drive-Away Kit or Magnetic Driveaway Kit can be used
• When using a drive-away kit, remove the figure-of-8 profile to drive-away

Velcro Loops Method

• For vehicles fitted with roof rails.
• Attach the Velcro straps, fitted along the top edge of the tunnel, around the roof rail.
• Undo Velcro to drive-away.

Pole & Clamp Method (optional accessory required)

• Requires gutter to run the length of the awning tunnel
• Simply thread pole into sleeve on tunnel edge
• Rest the pole in gutter and secure with clamps
• Remove clamps and pole from gutter to drive-away